Projectiondesign F3 XGA-6 Guía de usuario descargar pdf (Pagina 25)

english

MENU SYSTEM

UTILITIES SUB MENU

system information

Displays information about the source and projector status.

OSD

Turn the On Screen Display on (display) or off (hide) during source

scan.

OSD timeout

Defines how long OSD is displayed after last key action before it

disappears from the screen.

OSD background

Select background mode, whether transparent or opaque.

reset

Resets the projector to its basic settings. All parameters available in

the various menus are reset to their factory values.

service menu

For service personnel only. A special service code is needed to access

internal calibration controls and status information. Not accessible to

the user.

test image

Applies a fixed test image for set-up purposes.

PIN code

Activate or de-activate PIN code. The PIN code allows controlled use

of the projector.

PIN enable

Enable PIN code.

PIN disable

Disable PIN code.

PIN change

To change PIN code, enter old code, then new code twice.

LCD options.

Define options for the rear monitor LCD.

LCD timeout

Select timeout when LCD turns off after use.

LCD dim level

Select intensity in LCD backlight.

calibrate source

Allows calibration of projector to analog RGB source. RGB (VGA,

BNC) sources typically have a slight difference between the signal

levels of R, G and B, which is compensated for. Correct calibration

requires use of proper test-image with upper half light grey 240 and

the lower half dark grey 16.

system information press

OSD on off

OSD timeout 50 seconds

OSD background opaque translucent

reset press

service menu press

test image hide show

PIN CODE press

LCD options press

calibrate source press

FOR ALL

source: YPbPr brightness: 60

format: 480p NTSC contrast: 50

mode: 51 color: 40

software:

F3 301.35

sharpness: 3

white boost: 10 gamma: film 1

RC-ID 0 color temp: 6500K

lamp 1: lamp 2:

- runtime: 0 hrs - runtime: 0 hrs

- remaining: 1999 hrs - remaining: 1999 hrs

- power: 100% - power: 100 %

ens mounted:

standard (1.7-2.5 : 1)

MAC:

IP address:

LAN is not selected projector port:

subnet:

LAN is not selected X-Port 1 port:

gateway:

LAN is not selected

serial nr.: total runtime: 0 hrs

SYSTEM INFORMATION

PIN enable press

PIN disable press

PIN change press

PIN CODE - FOR ALL

LCD timeout 15 minutes

LCD dim level 100

LCD OPTIONS - FOR ALL

CALIBRATION TEST IMAGE

Downloaded From projector-manual.com Projectiondesign Manuals

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 35 36

Comentarios a estos manuales

Sin comentarios

Projectiondesign F3 XGA-6 Guía de usuario Pagina 25

Comentarios a estos manuales

Relacionado con productos y manuales para Proyectores de datos Projectiondesign F3 XGA-6