Projectiondesign F35 Guía de usuario descargar pdf (Pagina 23)

english

www.projectiondesign.com

5.5 Connecting and cables

NOTE! Before setting up, switch off all equipment and disconnect the power cord.

5.5.1 Setting up a video source

For best quality video, connect a digital video source using the HDMI 1.3a interface (A) in Fig-

ure 5-4. Both HDMI inputs are HDCP copy protection compliant. Depending on cable quality,

the projector is supporting the use of cables with lengths up 20 meters (65 feet).

Figure 5-4. Connecting a video source

5.5.2 Setting up a computer source

The projector may be connected to up to four computer sources simultaneously, using the

HDMI (A) and/or DVI-D (B) interfaces, shown in Figure 5-5. These interfaces are all-digital and

will yield a projected image with very low noise.

Both DVI and HDMI are HDCP compliant with sources up to 1920x1200@60Hz (single link

source up to 165 Mhz).

Figure 5-5. Connecting a computer source

NOTE! HDCP is not supported on higher resolution sources like 2560x1600@60Hz

(WQXGA).

Connect the power cord after the DVI cable is inserted properly.

5.5.3 Connecting command and control interfaces

The projector is supporting RS-232 and LAN command and control interfaces. Use the ASCII

based, simple instruction set (SIS) protocol to communicate with the projector. A detailed

description of the ASCII protocol is available for download at www.projectiondesign.com.

Connect the power cord after the selected command and control cables are inserted

properly.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 41 42

Sin comentarios

Projectiondesign F35 Guía de usuario Pagina 23